作者:绵阳快速门批发 发布时间: 2019/7/1 14:54:58
「绵阳堆积门」快速门电控系统连接时注意问题
Attention Problems in Connecting Electronic Control System of "Mianyang Accumulated Gate" Fast Gate
快速门电控系统连接时注意问题
Attention Problems in Connecting Electronic Control System of Fast Gate
1、当需要对控制系统进行打开、连接、保养或者检查的时候,需要将主电路电源切断。
1. When the control system needs to be opened, connected, maintained or checked, the power supply of the main circuit needs to be cut off.
2、主电源切断后,控制系统在5分钟内也有带电,内部电容会有一个延迟存电。
2. After the main power supply is cut off, the control system will also be charged within 5 minutes, and the internal capacitance will have a delayed storage.
4、实现接线后,在进行第一次运行的时候,必须对控制箱的接线和电机的接线进行细致的检查。尤其电机等部件是否连接正确,否则可能对变频器造成不可修复的损坏。
4. After wiring, the wiring of control box and motor must be carefully checked during the first operation.Especially if the motor and other components are connected correctly, otherwise it may cause irreparable damage to the frequency converter.
5、所有从控制电源至控制系统的电源绝缘必须良好,推荐应用大于230V的检测设备对电源的绝缘层进行检测。
5. All the power supply insulation from the control power supply to the control system must be good. It is recommended that the insulation layer of the power supply be tested by the testing equipment larger than 230V.
7、快速门由于存在告诉运动而使门帘之间摩擦,在摩擦的过程中可能带有大批静电,如果不及时释放,可能回导致控制单元损坏。以是需要做放静电的相关保护措施。
Attention Problems in Connecting Electronic Control System of "Mianyang Accumulated Gate" Fast Gate
相关新闻: